lookiglo.blogg.se - Switcher cast for windows not working

SWITCHER CAST FOR WINDOWS NOT WORKING HOW TO
SWITCHER CAST FOR WINDOWS NOT WORKING UPDATE

Again, please make sure the selected interface card is on the same network domain as the SE-1200 MU device. If the SE-1200 MU control software cannot find the SE-1200 MU device, the software will continuously prompt you for an appropriate interface card. Once selected, click OK to start the scanning process.

Upon launch of the SE-1200 MU controller software, you will be prompted to select one Ethernet Interface Card. If you cannot remember your device IP, please contact your local Datavideo distributor for assistance as there is currently no reset function for network settings. Please note IP finder can only find devices that are on the same network domain as the PC. The SE-1200 MU controller software has a built-in IP finder, which is designed for PC with multiple Ethernet cards or DHCP network environment. With static, you can directly connect your SE-1200 to a PC with a standard patch cable for operation without a router.

Once you are connected, you can configure the switcher's network settings to a Static IP address if preferred.

SWITCHER CAST FOR WINDOWS NOT WORKING HOW TO

Please scroll down to the section "How to Connect Via A Router Over DHCP" for the guide on how to do this.

Please note that with Automatic IP settings you need a router or network that supports DHCP with in order to see the SE-1200 and assign it an IP address.

Some earlier SE-700 and SE-1200 units may have the static address 192.168.1.101, or have DHCP enabled.

The default IP of the SE-650 is the static address 192.168.1.101.

Please Note: that you can not change these settings using the DVIP app at this time, so you will need to change your network settings in order to connect to the switcher and change it to match your typical network settings.

It should appear on the list and tell you whether DHCP is enabled or what is the static IP address is.

Check that your computer or device running the DVIP program or app is connected to the same network as the SE-1200 and scan.Download the DVIP Tools software for Windows, MacOS, iOS, or Android.Please Note: If you are unable to connect via the default IP address, or you previously changed the IP address and lost that information, switchers that are firmware version 1.2.2.8 or later have support for discovery via our DVIP protocol.

SWITCHER CAST FOR WINDOWS NOT WORKING UPDATE

Update guide is on page 108 of the SE-1200 manual.

For the SE-1200, the firmware file for the update is contained within the control software once installed and connected.

For SE-650, SE-700, HS-1200, HS-1300, SE-3200, and HS-3200, the switcher is updated via USB using the switcher's menu screen, that guide is available How to Update the SE-650, HS-1200, and SE-700 Firmware.